If a tokio::sync::oneshot channel is closed (via the oneshot::Receiver::close method), a data race may occur if the oneshot::Sender::send method is called while the corresponding oneshot::Receiver is awaited or calling try_recv.

When these methods are called concurrently on a closed channel, the two halves of the channel can concurrently access a shared memory location, resulting in a data race. This has been observed to cause memory corruption.

Note that the race only occurs when both halves of the channel are used after the Receiver half has called close. Code where close is not used, or where the Receiver is not awaited and try_recv is not called after calling close, is not affected.

See tokio#4225 for more details.

ring::aead::quic::HeaderProtectionKey::new_mask() may panic when overflow checking is enabled. In the QUIC protocol, an attacker can induce this panic by sending a specially-crafted packet. Even unintentionally it is likely to occur in 1 out of every 2**32 packets sent and/or received.

On 64-bit targets operations using ring::aead::{AES_128_GCM, AES_256_GCM} may panic when overflow checking is enabled, when encrypting/decrypting approximately 68,719,476,700 bytes (about 64 gigabytes) of data in a single chunk. Protocols like TLS and SSH are not affected by this because those protocols break large amounts of data into small chunks. Similarly, most applications will not attempt to encrypt/decrypt 64GB of data in one chunk.

Overflow checking is not enabled in release mode by default, but RUSTFLAGS="-C overflow-checks" or overflow-checks = true in the Cargo.toml profile can override this. Overflow checking is usually enabled by default in debug mode.